Enterasys C3 Configuration Guide 11-1
11
Port Configuration
This chapter describes the Port Configuration set of commands and how to use them.
Port Configuration Summary
Port String Syntax Used in the CLI
Commands requiring a port-string parameter use the following syntax to designate port type, unit
or slot location, and port number:
port type.unit_or_slot number.port number
Where port type can be:
fe for 100-Mbps Ethernet
ge for 1-Gbps Ethernet
tg for 10-Gbps Ethernet
host for the host port
vlan for vlan interfaces
lag for IEEE802.3 link aggregation ports
Where unit_or_slotnumber can be:
1 - 8 for switch units in a stack
For information about... Refer to page...
Port Configuration Summary 11-1
Reviewing Port Status 11-2
Disabling / Enabling and Naming Ports 11-7
Setting Speed and Duplex Mode 11-10
Enabling / Disabling Jumbo Frame Support 11-13
Setting Auto-Negotiation and Advertised Ability 11-15
Setting Flow Control 11-21
Setting Port Link Traps and Link Flap Detection 11-23
Configuring Broadcast Suppression 11-34
Port Mirroring 11-37
Link Aggregation Control Protocol (LACP) 11-44
Configuring Protected Ports 11-61
To Next Page
Loading...
