router rip
26-2 IPv4 Basic Routing Protocol Configuration
Router Configuration Commands
The following commands are used to enter RIP router configuration mode and to configure RIP
routing.
router rip
Use this command to enable or disable RIP configuration mode. The no form of this command
disables RIP.
Syntax
router rip
no router rip
Parameters
None.
Defaults
None.
Mode
Global configuration: C3(su)->router(Config)#
Usage
You must execute the router rip command to enable the protocol before completing many RIP-
specific configuration tasks. For details on enabling configuration modes, refer to Table 24-2 in
“Enabling Router Configuration Modes” on page 24-2.
Activate split horizon or poison-reverse. “split-horizon poison” on page 26-4
Suppress sending routing updates. “passive-interface” on page 26-5
Control reception of routing updates “receive-interface” on page 26-6
Control advertising non-RIP routes. “redistribute” on page 26-6
Table 26-1 RIP Configuration Task List and Commands (Continued)
To do this... Use these commands...
For information about... Refer to page...
router rip 26-2
distance 26-3
no auto-summary 26-4
split-horizon poison 26-4
passive-interface 26-5
receive-interface 26-6
redistribute 26-6
To Next Page
Loading...
Need help?
General