clear spantree autoedge
13-34 Spanning Tree Configuration
Example
This example shows how to disable automatic edge port detection:
C3(rw)->set spantree autoedge disable
clear spantree autoedge
Use this command to reset automatic edge port detection to the default state of enabled.
Syntax
clear spantree autoedge
Parameters
None.
Defaults
None.
Mode
Switch command, Read-Write.
Example
This example shows how to reset automatic edge port detection to enabled:
C3(rw)->clear spantree autoedge
show spantree debug
Use this command to display Spanning Tree debug counters for one or more ports.
Syntax
show spantree debug [port port-string] [sid sid] [active]
Parameters
Defaults
If port?string is not specified, no port information will be displayed.
If sid is not specified, debug counters will be displayed for Spanning Tree 0.
Mode
Switch command, read-only.
port port-string (Optional) Displays debug counters for specific port(s).
sid sid (Optional) Displays the debug counters for a specific Spanning Tree
identifier. Valid values are 0 - 4094. If not specified, SID 0 is assumed.
active (Optional) Displays only the debug counters for ports that have
received at least one configuration or RSTP BPDU.
To Next Page
Loading...
Need help?
General