show snmp community
Enterasys C3 Configuration Guide 12-13
show snmp community
Use this command to display SNMP community names and status. In SNMPv1 and v2,
community names act as passwords to remote management.
Syntax
show snmp community [name]
Parameters
Defaults
If name is not specified, information will be displayed for all SNMP communities.
Mode
Switch command, read-only.
Example
This example shows how to display information about the SNMP “public” community name. For
a description of this output, refer to set snmp community (page 12-13).
C3(su)->show snmp community public
--- Configured community strings ---
Name = *********
Security name = public
Context =
Transport tag =
Storage type = nonVolatile
Status = active
set snmp community
Use this command to configure an SNMP community group.
Syntax
set snmp community community [securityname securityname] [context context]
[transport transport] [volatile | nonvolatile]
Parameters
name (Optional) Displays SNMP information for a specific community name.
community Specifies a community group name.
securityname
securityname
(Optional) Specifies an SNMP security name to associate with this
community.
context context (Optional) Specifies a subset of management information this community
will be allowed to access. Valid values are full or partial context names. To
review all contexts configured for the device, use the show snmp context
command as described in “show snmp context” on page 12-20.
To Next Page
Loading...
Need help?
General