Enterasys C3 Configuration Guide 25-1
25
IP Configuration
This chapter describes the Internet Protocol (IP) configuration set of commands and how to use
them.
Configuring Routing Interface Settings
Purpose
To enable routing interface configuration mode on the device, to create routing interfaces, to
review the usability status of interfaces configured for IP, to set IP addresses for interfaces, to
enable interfaces for IP routing at device startup, and to review the running configuration.
Commands
Router: Unless otherwise noted, the commands covered in this chapter can be executed only
when the device is in router mode. For details on how to enable router configuration modes, refer
to “Enabling Router Configuration Modes” on page 24-2.
For information about... Refer to page...
Configuring Routing Interface Settings 25-1
Configuring Tunnel Interfaces 25-8
Reviewing and Configuring the ARP Table 25-12
Configuring Broadcast Settings 25-16
Reviewing IP Traffic and Configuring Routes 25-19
Configuring ICMP Redirects 25-23
Note: For information about configuring tunnel interfaces, see “Configuring Tunnel Interfaces” on
page 25-8.
For information about... Refer to page...
show interface 25-2
interface 25-3
show ip interface 25-4
ip address 25-5
To Next Page
Loading...
