set port lacp
Enterasys C3 Configuration Guide 11-55
This example shows how to display summarized LACP status information for port ge.1.12:
C3(su)->show port lacp port ge.1.12 status summary
Port Aggr Actor System Partner System
Pri: System ID: Key: Pri: System ID: Key:
ge.1.12 none [(32768,00e0639db587,32768),(32768,000000000000, 1411)]
This example shows how to display LACP counters for port ge.1.12:
C3(su)->show port lacp port ge.1.12 counters
Port Instance: ge.1.12
LACPDUsRx: 11067
LACPDUsTx: 0
IllegalRx: 0
UnknownRx: 0
MarkerPDUsRx: 0
MarkerPDUsTx: 0
MarkerResponsePDUsRx: 0
MarkerResponsePDUsTx: 374
set port lacp
Use this command to set link aggregation parameters for one or more ports. These settings will
determine the specified underlying physical ports’ ability to join a LAG, and their administrative
state once aggregated.
Syntax
set port lacp port port-string {[aadminkey aadminkey] [aadminstate {lacpactive |
lacptimeout | lacpagg | lacpsync | lacpcollect | lacpdist | lacpdef | lacpexpire}]
[aportpri aportpri] [asyspri asyspri] [enable | [disable] [padminkey padminkey]
[padminport padminport] [padminportpri padminportpri] [padminstate {lacpactive |
lacptimeout | lacpagg | lacpsync | lacpcollect | lacpdist | lacpdef | lacpexpire}]
[padminsysid padminsysid] [padminsyspri padminsyspri]
Parameters
port port-string Specifies the physical port(s) on which to configure LACP. For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.
aadminkey
aadminkey
Sets the port’s actor admin key. LACP will use this value to form an oper
key and will determine which underlying physical ports are capable of
aggregating by comparing oper keys. Aggregator ports allow only
underlying ports with oper keys matching theirs to join their LAG. Valid
values are 1 - 65535. The default key value is 32768.
To Next Page
Loading...
Need help?
General