show port lacp
11-54 Port Configuration
Parameters
Defaults
None.
Mode
Switch command, read-only.
Usage
State definitions, such as ActorAdminState and Partner AdminState, are indicated with letter
abbreviations. If the show port lacp command displays one or more of the following letters, it
means the state is true for the associated actor or partner ports:
• E = Expired
• F = Defaulted
• D = Distributing (tx enabled)
• C = Collecting (rx enabled)
• S = Synchronized (actor and partner agree)
• G = Aggregation allowed
• S/L = Short/Long LACP timeout
• A/p = Active/Passive LACP
For more information about these states, refer to set port lacp (page 11-55) and the IEEE 802.3 2002
specification.
Examples
This example shows how to display detailed LACP status information for port ge.1.1
C3(su)-> show port lacp port ge.1.1 status detail
Global Link Aggregation state : Disabled
Port Instance: ge.1.1 Port enable state: Disabled
ActorPort: 1 PartnerAdminPort: 1
ActorSystemPriority: 32768 PartnerOperPort: 1
ActorPortPriority: 32768 PartnerAdminSystemPriority: 32768
ActorAdminKey: 32768 PartnerOperSystemPriority: 32768
ActorOperKey: 32768 PartnerAdminPortPriority: 32768
ActorAdminState: -----GLA PartnerOperPortPriority: 32768
ActorOperState: -F---GLA PartnerAdminKey: 1
ActorSystemID: 00:1F:45:47:81:FC PartnerOperKey: 1
SelectedAggID: None PartnerAdminState: -----GSA
AttachedAggID: None PartnerOperState: ------SA
MuxState: Detached PartnerAdminSystemID: 00:00:00:00:00:00
DebugRxState: Portdisable PartnerOperSystemID: 00:00:00:00:00:00
port port-string Displays LACP information for specific port(s). For a detailed description
of possible port-string values, refer to “Port String Syntax Used in the CLI”
on page 11-1.
status detail |
summary
Displays LACP status in detailed or summary information.
counters Displays LACP counter information.
To Next Page
Loading...
Need help?
General