Enterasys C3G124-24 - Show Netstat

show netstat
Enterasys C3 Configuration Guide 18-5
Examples
This example shows how to close a Telnet session to host 134.141.192.119:
C3(su)->disconnect 134.141.192.119
This example shows how to close the current console session:
C3(su)->disconnect console
show netstat
Use this command to display network layer statistics.
Syntax
show netstat [icmp | ip | routes | stats | tcp | udp]
Parameters
Defaults
If no parameters are specified, show netstat will be executed as shown in the example below.
Mode
Switch command, read-only.
Example
The following example shows how to display statistics for all the current active network
connections.
C3(su)->show netstat
Prot Local Address Foreign Address State
---- ----------------------------- ----------------------------- -----------
TCP 127.0.0.1.2222 0.0.0.0.* LISTEN
TCP 0.0.0.0.80 0.0.0.0.* LISTEN
TCP 0.0.0.0.23 0.0.0.0.* LISTEN
TCP 10.1.56.17.23 134.141.99.104.47718 ESTABLISHED
UDP 0.0.0.0.17185 0.0.0.0.*
UDP 127.0.0.1.49152 127.0.0.1.17185
UDP 0.0.0.0.161 0.0.0.0.*
UDP 0.0.0.0.* 0.0.0.0.*
UDP 0.0.0.0.514 0.0.0.0.*
The following table describes the output of this command.
icmp (Optional) Shows Internet Control Message Protocol (ICMP) statistics.
ip (Optional) Shows Internet Protocol (IP) statistics.
routes (Optional) Shows the IP routing table.
stats (Optional) Shows all statistics for TCP, UDP, IP, and ICMP.
tcp (Optional) Shows Transmission Control Protocol (TCP) statistics.
udp (Optional) Shows User Datagram Protocol (UDP) statistics.