Configuring VRRP
Enterasys C3 Configuration Guide 27-29
Configuring VRRP
Purpose
To enable and configure the Virtual Router Redundancy Protocol (VRRP). This protocol eliminates
the single point of failure inherent in the static default routed environment by transferring the
responsibility from one router to another if the original router goes down. VRRP-enabled routers
decide who will become master and who will become backup in the event the master fails.
Commands
router vrrp
Use this command to enable or disable VRRP configuration mode. The no form of this command
removes all VRRP configurations from the running configuration.
Syntax
router vrrp
no router vrrp
Parameters
None.
Defaults
None.
* Advanced License Required *
VRRP is an advanced routing feature that must be enabled with a license key. If you have purchased an
advanced license key, and have enabled routing on the device, you must activate your license as described in
the chapter entitled “Activating Licensed Features” in order to enable the VRRP command set. If you wish to
purchase an advanced routing license, contact Enterasys Networks Sales.
For information about... Refer to page...
router vrrp 27-29
create 27-30
address 27-31
priority 27-32
master-icmp-reply 27-32
advertise-interval 27-33
preempt 27-34
enable 27-35
ip vrrp authentication-key 27-35
show ip vrrp 27-36
To Next Page
Loading...
