Enterasys C3G124-24 - Show Lldp; Show Lldp Port Status

show lldp
Enterasys C3 Configuration Guide 10-15
show lldp
Use this command to display LLDP configuration information.
Syntax
show lldp
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display LLDP configuration information.
C3(ro)->show lldp
Message Tx Interval : 30
Message Tx Hold Multiplier : 4
Notification Tx Interval : 5
MED Fast Start Count : 3
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
MED Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
show lldp port status
Use this command to display the LLDP status of one or more ports. The command lists the ports
that are enabled to send and receive LLDP PDUs. Ports are enabled or disabled with the set lldp
port status command.
Syntax
show lldp port status [port-string]
clear lldp 10-31
clear lldp port status 10-31
clear lldp port trap 10-32
clear lldp port med-trap 10-32
clear lldp port location-info 10-33
clear lldp port network-policy 10-33
clear lldp port tx-tlv 10-34
For information about... Refer to page...