Enterasys C3G124-24 - Clear Switch Stack-Ports Length; Show Switch Stack-Ports Length

clear switch stack-ports length
Enterasys C3 Configuration Guide 2-13
Down standard
clear switch stack-ports length
Use this command to clear the stack port lengths to the default of standard for one or all swtiches
in the stack.
Syntax
clear switch stack-ports length [unit]
Parameters
Defaults
If no switch is specified, all switches in the stack have their stack port lengths cleared to use a
standard length cable.
Mode
Switch mode, read-write
Example
This example clears the stack port cable length on switch unit 1.
C3(su)->clear switch stack-ports length 1
show switch stack-ports length
Use this command to display the current stack port cable configuration.
Syntax
show switch stack-ports length [unit]
Parameters
Defaults
If no switch is specified, all switches in the stack are displayed.
Mode
Switch command, read-only.
Example
This example shows the stack port cable length configuration for all switches in the stack.
C3(su)->show switch stack-ports length
Stacking
Switch Port Length
unit (Optional) Specifies the switch in the stack to clear stack port lengths.
unit (Optional) Specifies the switch in the stack to show stack port cable
configurations.