set rmon capture
21-22 RMON Configuration
Owner monitor
captureEntry= 1 Buff.control= 28062
--------------------------------------------
Pkt ID 9 Pkt time 1 days 0 hours 51 minutes 15 seconds
Pkt Length 93 Pkt status 0
Data:
00 00 5e 00 01 01 00 01 f4 00 7d ce 08 00 45 00
00 4b b4 b9 00 00 40 11 32 5c 0a 15 43 05 86 8d
bf e5 00 a1 0e 2b 00 37 cf ca 30 2d 02 01 00 04
06 70 75 62 6c 69 63 a2 20 02 02 0c 92 02 01 00
02 01 00 30 14 30 12 06 0d 2b 06 01 02 01 10 07
01 01 0b 81 fd 1c 02 01 01 00 11 0b 00
set rmon capture
Use this command to configure an RMON capture entry.
Syntax
set rmon capture index {channel [action {lock}] [slice slice] [loadsize loadsize]
[offset offset] [asksize asksize] [owner owner]}
Parameters
Defaults
If not specified, action defaults to lock.
If not specified, offset defaults to 0.
If not specified, asksize defaults to -1 (which will request as many octets as possible).
If slice is not specified, 1518 will be applied.
If loadsize is not specified, 100 will be applied.
If owner is not specified, it will be set to monitor.
index Specifies a buffer control entry.
channel Specifies the channel to which this capture entry will be applied.
action lock (Optional) Specifies the action of the buffer when it is full as:
• lock - Packets will cease to be accepted
slice slice (Optional) Specifies the maximum octets from each packet to be saved in
a buffer. Currently, the only value allowed is 1518.
loadsize loadsize (Optional) Specifies the maximum octets from each packet to be
downloaded from the buffer. The default is 100.
offset offset (Optional) Specifies the first octet from each packet that will be retrieved.
asksize asksize (Optional) Specifies the requested maximum octets to be saved in this
buffer. Currently, the only value accepted is -1, which requests as many
octets as possible.
owner (Optional) Specifies the name of the entity that configured this entry.
To Next Page
Loading...
Need help?
General