Enterasys C3G124-24 User Manual

set dhcp ping
22-8 DHCP Server Configuration
Example
This example clears the previously excluded range of IP addresses between 192.168.1.88 through
192.168.1.100.
C3(rw)->clear dhcp exclude 192.168.1.88 192.168.1.100
set dhcp ping
Use this command to configure the number of ping packets the DHCP server sends to an IP
address before assigning the address to a requesting client.
Syntax
set dhcp ping packets number
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example sets the number of ping packets sent to 3.
C3(rw)->set dhcp ping packets 3
clear dhcp ping
Use this command to reset the number of ping packets sent by the DHCP server back to the
default value of 2.
Syntax
clear dhcp ping packets
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
packets number Specifies the number of ping packets to be sent. The value of number can
be 0, or range from 2 to 10. Entering 0 disables this function. The default
value is 2 packets.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English