Enterasys C3G124-24 - Show System

show system
Enterasys C3 Configuration Guide 3-7
61.200.10.10 61.200.10.10 UH 38 lo0 5
127.0.0.1 127.0.0.1 UH 0 lo0 5
INET6 route table
Destination Gateway Flags Use If Metric
::/0 FE80::21F:45FF:FE09:E757%dtl0 UG 339 host 10
::1 ::1 UH 0 lo0 5
2001:FF:7010:FF::/64 2001:FF:7010:FF::FFFF UmC 0 host 5
2001:FF:7010:FF::FFFF 2001:FF:7010:FF::FFFF UH 0 lo0 5
FE80::21F:45FF:FEB2:B89C%host 2001:FF:7010:FF::FFFF UH 0 lo0 5
show system
Use this command to display system information, including contact information, power and fan
tray status and uptime.
Syntax
show system
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display system information:
C3(su)->show system
System contact:
System location:
System name:
Switch 1
--------
PS1-Status PS2-Status
---------- ----------
Ok Not Installed and/or Not Operating
Fan1-Status Fan2-Status
----------- -----------
Ok Ok
Temp-Alarm
-----------
off
Thermal Threshold: 58%
Temp alarm max threshold: 100%
Temp alarm trap: disabled
Temp alarm syslog: disabled
Uptime d,h:m:s Logout