show ip vrrp
27-36 IPv4 Advanced Routing Protocol Configuration
Example
This example shows how to set the VRRP authentication key chain to “password” on the VLAN 1
interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip vrrp authentication-key password
show ip vrrp
Use this command to display VRRP routing information.
Syntax
show ip vrrp
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display VRRP information
C3(su)->router(Config)#show ip vrrp
-----------VRRP CONFIGURATION-----------
Vlan Vrid State Owner AssocIpAddr Priority
2 1 Initialize 0 25.25.2.1 100
To Next Page
Loading...
