configure
3-40 Basic Configuration
Defaults
By default, show config will display all non-default configuration information for all facilities.
Mode
Switch command, read-only.
Usage
The separate facilities that can be displayed by this command are identified in the display of the
current configuration by a # preceding the facility name. For example, “#port” indicates the facility
name “port.”
The output of this command obfuscates user passwords for all access modes, when the security
profile = normal. When the security profile = C2, user passwords are obfuscated for super-user
access, but redacted entirely for read-write and read-only access. The line containing the password
is also commented out in the output.
Examples
This example shows how to write the current configuration to a file named save_config2:
C3(rw)->show config all outfile configs/save_config2
This example shows how to display configuration for the facility “port”.
C3(rw)->show config port
This command shows non-default configurations only.
Use 'show config all' to show both default and non-default configurations.
begin
!
#***** NON-DEFAULT CONFIGURATION *****
!
!
#port
set port jumbo disable ge.1.1
!
end
configure
Use this command to execute a previously downloaded configuration file stored on the switch.
Syntax
configure filename [append]
Parameters
filename Specifies the path and file name of the configuration file to execute.
append (Optional) Appends the configuration file contents to the current
configuration. This is equivalent to typing the contents of the config file
directly into the CLI and can be used, for example, to make incremental
adjustments to the current configuration.
To Next Page
Loading...
Need help?
General