show ipv6 ospf range
Enterasys C3 Configuration Guide 31-45
show ipv6 ospf range
This command displays information about the area ranges for the specified area.
Syntax
show ipv6 ospf range areaid
Parameters
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Example
This example displays range information for area 20.
C3(su)->router#show ipv6 ospf range 20
Area ID IPv6 Prefix/Prefix Length Lsdb Type Advertisement
--------------- ------------------------- --------------- -------------
0.0.0.20 3345:1234::/64 Summary Link Enabled
Table 31-11 provides an explanation of the command output.
Table 31-10 show ipv6 ospf neighbor routerid Output Details
Output Field What It Displays...
Interface Interface of the local router.
Area ID OSPFv3 area ID associated with the interface.
Options An integer value that indicates the optional OSPFv3 capabilities
supported by the neighbor. These are listed in its Hello packets.
This enables received Hello Packets to be rejected (that is,
neighbor relationships will not even start to form) if there is a
mismatch in certain crucial OSPFv3 capabilities.
Router Priority Router priority for the specified interface.
Dead Timer Due Amount of time, in seconds, to wait before the router assumes the
neighbor is unreachable.
State State of the neighboring routers.
Events Number of times this neighbor relationship has changed state, or
an error has occurred.
Retransmission Queue Length Integer representing the current length of the retransmission
queue of the specified neighbor router Id of the specified interface.
areaid Specifies the area ID in IP address format (dotted-quad) or as a decimal
value.
To Next Page
Loading...
