show pwa
32-78 Authentication and Authorization Configuration
show pwa
Use this command to display port web authentication information for one or more ports.
Syntax
show pwa [port-string]
Parameters
Defaults
If port-string is not specified, PWA information will be displayed for all ports.
Mode
Switch command, read-only.
Example
This example shows how to display PWA information for ge.2.1:
C3(su)->show pwa ge.2.1
PWA Status - enabled
PWA IP Address - 192.168.62.99
PWA Protocol - PAP
PWA Enhanced Mode - N/A
PWA Logo - enabled
PWA Guest Networking Status - disabled
PWA Guest Name - guest
PWA Redirect Time - N/A
Port Mode AuthStatus QuietPeriod MaxReq
-------- ---------------- -------------- ----------- ---------
ge.2.1 disabled disconnected 60 16
Table 32-8 provides an explanation of the command output.
port-string (Optional) Displays PWA information for specific port(s).
Table 32-8 show pwa Output Details
Output Field What It Displays...
PWA Status Whether or not port web authentication is enabled or disabled. Default state of
disabled can be changed using the set pwa command as described in “set pwa” on
page 32-79.
PWA IP Address IP address of the end station from which PWA will prevent network access until the
user is authenticated. Set using the set pwa ipaddress command as described in
“set pwa ipaddress” on page 32-82.
PWA Protocol Whether PWA protocol is CHAP or PAP. Default setting of PAP can be changed
using the set pwa protocol command as described in “set pwa protocol” on
page 32-82.
PWA Enhanced
Mode
Whether PWA enhanced mode is enabled or disabled. Default state of disabled can
be changed using the set pwa enhancedmode command as described in “set pwa
enhancedmode” on page 32-88.
To Next Page
Loading...
