show mac unreserved-flood
18-16 Network Management
show mac unreserved-flood
Use this command to display the state of forwarding of several standard group multicast MAC
addresses.
Syntax
show mac unreserved-flood
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example displays the state of forwarding of the group multicast MAC addresses.
C3(su)->show mac unreserved-flood
mac unreserved flood is disabled.
set mac unreserved-flood
Use this command to enable or disable forwarding of several standard group multicast MAC
addresses. See the Usage section below for details.
Syntax
set mac unreserved-flood {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Usage
The following addresses will be forwarded when this function is enabled:
01:80:C2:00:00:11
01:80:C2:00:00:14
01:80:C2:00:00:15
The default state is disabled, and these addresses will not be forwarded.
disable | enable Disables or enables forwarding of several standard group multicast
MAC addresses. .
To Next Page
Loading...
Need help?
General