Enterasys C3G124-24 - Setting Basic Switch Properties

Setting Basic Switch Properties
3-2 Basic Configuration
Setting Basic Switch Properties
Purpose
To display and set the system IP address and other basic system (switch) properties.
Commands
Table 3-2 Optional CLI Setup Commands
Task CLI commands
Refer to
page...
Save the active configuration. save config 3-37
Enable or disable SSH. set ssh enable | disable 32-89
Enable or disable Telnet. set telnet {enable | disable} [inbound |
outbound | all]
3-33
Enable or disable HTTP
management (WebView).
set webview {enable | disable} 3-51
Enable or disable SNMP port link
traps.
set port trap port-string {enable | disable} 11-24
Set the per port broadcast limit set port broadcast port-string threshold-value 11-35
Configure a VLAN. set vlan create vlan-id 14-5
set port vlan port-string vlan-id modify-egress 14-9
Set a Syslog server IP and
severity
set logging server index ip-addr ip-addr
severity severity state enable
19-4
Configure and enable a RADIUS
server.
set radius server index ip-addr
port [secret-value]{realm {management-access |
any | network-access}
32-8
set radius enable 32-8
For information about... Refer to page...
show ip address 3-3
set ip address 3-4
clear ip address 3-5
show ip protocol 3-5
set ip protocol 3-6
show ip route 3-6
show system 3-7
show system hardware 3-8
show system utilization 3-9
set system utilization 3-10
clear system utilization 3-11
show system enhancedbuffermode 3-11
set system enhancedbuffermode 3-12