ip rip enable
Enterasys C3 Configuration Guide 26-7
Mode
Router configuration: C3(su)->router(Config-router)#
Defaults
If subnets is not specified, only non-subnetted routes will be redistributed.
If metric value is not specified, 1 will be applied.
Example
This example shows how to redistribute routing information discovered through static routes will
be redistributed into RIP update messages:
C3(su)->router(Config)#router rip
C3(su)->router(Config-router)#redistribute static
Interface Configuration Commands
The following commands are used to configure RIP on specific interfaces.
ip rip enable
Use this command to enable RIP on an interface. The no form of this command disables RIP on an
interface: By default, RIP is disabled on all interfaces.
Syntax
ip rip enable
no ip rip enable
Parameters
None.
Defaults
None.
metric metric value (Optional) Specifies a metric for the connected, OSPF or static
redistribution route. This value should be consistent with the designation
protocol.
subnets (Optional) Specifies that connected, OSPF or static routes that are
subnetted will be redistributed.
For information about... Refer to page...
ip rip enable 26-7
ip rip send version 26-8
ip rip receive version 26-8
ip rip authentication-key 26-9
ip rip message-digest-key 26-10
To Next Page
Loading...
Need help?
General