show gvrp
14-22 802.1Q VLAN Configuration
show gvrp
Use this command to display GVRP configuration information.
Syntax
show gvrp [port-string]
Parameters
Defaults
If port-string is not specified, GVRP configuration information will be displayed for all ports and
the device.
Mode
Switch command, read-only.
Example
This example shows how to display GVRP status for the device and for fw.2.1:
C3(su)->show gvrp ge.2.1
Global GVRP status is enabled.
Port Number GVRP status
----------- -----------
ge.2.1 disabled
show garp timer
Use this command to display GARP timer values for one or more ports.
Syntax
show garp timer [port-string]
Parameters
Defaults
If port-string is not specified, GARP timer information will be displayed for all ports.
Mode
Switch command, read-only.
port-string (Optional) Displays GVRP configuration information for specific port(s). For
a detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.
port-string (Optional) Displays GARP timer information for specific port(s). For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.