Enterasys C3G124-24 - Show Ipv6 Ospf Stub Table; Show Ipv6 Ospf Range Output Details; Show Ipv6 Ospf Stub Table Output Details

show ipv6 ospf stub table
31-46 OSPFv3 Configuration
show ipv6 ospf stub table
This command displays the OSPFv3 stub table, if OSPFv3 is initialized on the switch.
Syntax
show ipv6 ospf stub table
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Example
This example displays the OSPFv3 stub table information.
C3(su)->router# show ipv6 ospf stub table
AreaId TypeofService Metric Val Import SummaryLSA
---------------- ------------- ---------- -----------------
0.0.0.20 Normal 1 Enable
Table 31-12 provides an explanation of the command output.
Table 31-11 show ipv6 ospf range Output Details
Output Field What It Displays...
Area ID The area ID of the requested OSPFv3 area.
IPv6 Prefix/Prefix Length An IPv6 prefix and length which represents a configured area
range.
Lsdb Type The type of link advertisement associated with this area range.
Advertisement The status of the advertisement: enabled or disabled.
Table 31-12 show ipv6 ospf stub table Output Details
Output Field What It Displays...
Area ID A 32-bit identifier for the created stub area.
Type of Service Type of service associated with the stub metric. For this release,
Normal TOS is the only supported type.
Metric Val The metric value is applied based on the TOS. It defaults to the
least metric of the type of service among the interfaces to other
areas. The OSPFv3 cost for a route is a function of the metric
value.
Import Summary LSA Controls the import of summary LSAs into stub areas.