Enterasys C3G124-24 - Show Tacacs Command; Set Tacacs Command

show tacacs command
Enterasys C3 Configuration Guide 36-9
show tacacs command
Use this command to display the status (enabled or disabled) of TACACS+ accounting or
authorization on a per-command basis.
Syntax
show tacacs command {accounting | authorization}
Parameters
Defaults
None.
Mode
Switch command, Read-Write.
Example
This example shows how to display the state of the TACACS+ client’s command authorization.
C3(rw)->show tacacs command authorization
TACACS+ command authorization state: enabled
set tacacs command
Use this command to enable or disable TACACS+ accounting or authorization on a per-command
basis.
Syntax
set tacacs command {accounting | authorization} {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, Read-Write.
Usage
In order for per-command accounting or authorization by a TACACS+ server to take place, the
command must be executed within an authorized session.
accounting Display the status of TACACS+ accounting on a per-command basis.
authorization Display the status of TACACS+ authorization on a per-command basis.
accounting |
authorization
Specifies either TACACS+ accounting or authorization to be enabled or
disabled.
enable | disable Enable or disable accounting or authorization on a per-command basis.