show dot1x auth-config
Enterasys C3 Configuration Guide 32-21
show dot1x auth-config
Use this command to display 802.1X authentication configuration settings for one or more ports.
Syntax
show dot1x auth-config [authcontrolled-portcontrol] [maxreq] [quietperiod]
[reauthenabled] [reauthperiod] [servertimeout] [supptimeout] [txperiod]
[port-string]
Parameters
Defaults
If no parameters are specified, all 802.1X settings will be displayed.
If port-string is not specified, information for all ports will be displayed.
Mode
Switch command, read-only.
Examples
This example shows how to display the EAPOL port control mode for ge.1.1:
C3(su)->show dot1x auth-config authcontrolled-portcontrol ge.1.1
Port 1: Auth controlled port control: Auto
This example shows how to display the 802.1X quiet period settings for ge.1.1:
C3(su)->show dot1x auth-config quietperiod ge.1.1
Port 1: Quiet period: 30
This example shows how to display all 802.1X authentication configuration settings for ge.1.1:
C3(ro)->show dot1x auth-config ge.1.1
authcontrolled-
portcontrol
(Optional) Displays the current value of the controlled Port control
parameter for the port.
maxreq (Optional) Displays the value set for maximum requests currently in use by
the backend authentication state machine.
quietperiod (Optional) Displays the value set for quiet period currently in use by the
authenticator PAE state machine.
reauthenabled (Optional) Displays the state of reauthentication control used by the
Reauthentication Timer state machine.
reauthperiod (Optional) Displays the value, in seconds, set for the reauthentication
period used by the reauthentication timer state machine.
servertimeout (Optional) Displays the server timeout value, in seconds, currently in use
by the backend authentication state machine.
supptimeout (Optional) Displays the authentication supplicant timeout value, in
seconds, currently in use by the backend authentication state machine.
txperiod (Optional) Displays the transmission period value, in seconds, currently in
use by the authenticator PAE state machine.
port-string (Optional) Limits the display of desired information information to specific
port(s). For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.
To Next Page
Loading...
Need help?
General