show system utilization
Enterasys C3 Configuration Guide 3-9
Mode
Switch command, read-only.
Example
This example shows how to display the system’s hardware configuration. Please note that the
information you see displayed may differ from this example.
C3(su)->show system hardware
UNIT 1 HARDWARE INFORMATION
---------------------------
Model:
<platform specific>
Serial Number: <switch specific>
Vendor ID: 0xbc00
Base MAC Address: 00:11:88:B1:76:C0
Hardware Version: BCM56514 REV 1
FirmWare Version: 06.61.00.0052
Boot Code Version: 01.00.52
CPLD Version: 2.0
show system utilization
Use this command to display detailed information about the processor running on the switch, or
the overall memory usage of the Flash and SDRAM storage devices on the unit, or the processes
running on the switch. Only the memory usage in the master unit of a stack is shown.
Syntax
show system utilization {cpu | storage | process}
Parameters
Defaults
None.
Mode
Switch command, read-only.
Examples
This example shows how to display the system’s CPU utilization:
C3(ro)->show system utilization cpu
CPU Utilization Threshold Traps enable: Threshold = 80.0%
Total CPU Utilization:
Switch CPU 5 sec 1 min 5 min
-----------------------------------------------
1 1 50% 49% 49%
cpu Display information about the processor running on the switch.
storage Display information about the overall memory usage on the switch.
process Display information about the processes running on the switch.
To Next Page
Loading...
Need help?
General