set macauthentication macreauthenticate
Enterasys C3 Configuration Guide 32-37
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to force ge.2.1 though 5 to reauthenticate:
C3(su)->set macauthentication portreauthentication ge.2.1-5
set macauthentication macreauthenticate
Use this command to force an immediate reauthentication of a MAC address.
Syntax
set macauthentication macreauthenticate mac-addr
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to force the MAC authentication session for address 00-60-97-b5-4c-07
to reauthenticate:
C3(su)->set macauthentication macreauthenticate 00-60-97-b5-4c-07
set macauthentication reauthperiod
Use this command to set the MAC reauthentication period (in seconds). This is the time lapse
between attempts to reauthenticate any current MAC address authenticated to a port.
Syntax
set macauthentication reauthperiod time port-string
port-string Specifies MAC authentication port(s) to be reauthenticated. For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.
mac-addr Specifies the MAC address of the session to reauthenticate.
To Next Page
Loading...
