ipv6 ospf transmit-delay
31-28 OSPFv3 Configuration
Parameters
Defaults
Default value is 4 seconds.
Mode
Router interface configuration: C3(su)->router(Config-if(Vlan 1))#
Usage
The retransmit interval is the number of seconds between link-state advertisement
retransmissions for adjacencies belonging to this router interface. This value is also used when
retransmitting database description and link-state request packets.
Use the no form of this command to reset the retransmit interval to the default value of 4 seconds.
Example
This example sets the retransmit interval to 10 seconds for router interface VLAN 7.
C3(su)->router(Config)# interface vlan 7
C3(su)->router(Config-if(Vlan 7))# ipv6 ospf retransmit-interval 10
ipv6 ospf transmit-delay
This command sets the OSPFv3 transmit delay for the router interface.
Syntax
ipv6 ospf transmit-delay seconds
no ipv6 ospf transmit-delay
Parameters
Defaults
Default value is 1 second.
Mode
Router interface configuration: C3(su)->router(Config-if(Vlan 1))#
Usage
The transmit delay, specified in seconds, sets the estimated number of seconds it takes to transmit
a link state update packet over this interface.
Use the no form of this command to return the transmit delay to the default value of 1 seconds.
seconds Specifies the retransmit interval value, which can range from 0 to 3600
seconds.
seconds Specifies the transmit delay, which can range from 1 to 3600 seconds.
To Next Page
Loading...
Need help?
General