clear vlanauthorization
Enterasys C3 Configuration Guide 32-55
Defaults
By default, administrative egress is set to untagged.
Mode
Switch command, read-write.
Example
This example shows how to enable the insertion of the RADIUS assigned VLAN to an 802.1q tag
for all outbound frames for ports 10 through 15 on unit/module number 3.
C3(rw)->set vlanauthorization egress tagged ge.3.10-15
clear vlanauthorization
Use this command to return port(s) to the default configuration of VLAN authorization disabled,
egress untagged.
Syntax
clear vlanauthorization [port-string]
Parameters
Defaults
If no port string is entered, all ports a will be reset to default configuration with VLAN
authorization disabled and egress frames untagged.
Mode
Switch command, read-write.
Example
This example show how to clear VLAN authorization for all ports on slots 3, 4, and 5:
C3(rw)->clear vlanauthorization ge.3-5.*
show vlanauthorization
Displays the VLAN authentication status and configuration information for the specified ports.
Syntax
show vlanauthorization [port-string]
port-string (Optional) Specifies which ports are to be restored to default
configuration. If no port string is entered, the action will be a global
setting. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.
To Next Page
Loading...
