Enterasys C3G124-24 - Set Multiauth Port; Show Multiauth Port

show multiauth port
Enterasys C3 Configuration Guide 32-45
Mode
Switch command, read-write.
Example
This example shows how to clear the multiple authentication precedence:
C3(rw)->clear multiauth precedence
show multiauth port
Use this command to display multiple authentication properties for one or more ports.
Syntax
show multiauth port [port-string]
Parameters
Defaults
If port-string is not specified, multiple authentication information will be displayed for all ports.
Mode
Switch command, read-only.
Example
This example shows how to display multiple authentication information for ports ge.3.1-4. The
number of “Max users” shown by this command varies depending on the platform.
C3(rw)->show multiauth port ge.3.1-4
Port Mode Max Allowed Current
users users users
------------ ------------ ---------- ---------- ----------
ge.3.1 auth-opt n 1 0
ge.3.2 auth-opt n 10
ge.3.3 auth-opt n 10
ge.3.4 auth-opt n 10
set multiauth port
Use this command to set multiple authentication properties for one or more ports.
Syntax
set multiauth port mode {auth-opt | auth-reqd | force-auth | force-unauth} |
numusers numusers port-string
port-string (Optional) Displays multiple authentication information for specific port(s).