ip pimsm query-interval
27-40 IPv4 Advanced Routing Protocol Configuration
ip pimsm query-interval
This command configures the transmission frequency of hello messages in seconds between
PIM-enabled neighbors. The no form of this command resets the hello interval to the default, 30
seconds.
Syntax
ip pimsm query-interval seconds
no ip pimsm query-interval
Parameters
Defaults
None.
Mode
Interface configuration: C3(su)->router(Config-if(Vlan 1))#
Example
This example shows how to set the hello interval rate to 100 seconds.
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip pimsm query-interval 100
show ip pimsm
Use this command to display system-wide PIM-SM routing information.
Syntax
show ip pimsm
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display PIM information.
C3(su)->router# show ip pimsm
Admin Mode Enable
Join/Prune Interval (secs) 60
seconds This field has a range of 10 to 3600 seconds. Default is 30.
To Next Page
Loading...
