Enterasys C3G124-24 - Clear System Service-Class

Configuring Service Access Control Lists clear system service-class
35-6
Mode
Switch command, read-only.
Example
This example activates the service ACL named my-sacl, then displays the service class status.
C3(su)->set system service-class my-sacl
C3(su)->show system service-class
system service-class is enabled, using access list my-sacl.
clear system service-class
Use this command to de-activate a service ACL or remove the restriction of management to the
console port.
Syntax
clear system service-class
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Usage
If a service ACL has been activated, this command will de-activate the ACL.
If console-only management has been set, this command will remove console-only management.
Example
This example de-activates the active service ACL my-sacl.
C3(su)->set system service-class my-sacl
C3(su)->show system service-class
system service-class is enabled, using access list my-sacl.
C3(su)->clear system service-class
C3(su)->show system service-class
system service-class is disabled.