Enterasys C3G124-24 - Set Pwa Maxrequest; Set Pwa Portcontrol

set pwa maxrequest
32-86 Authentication and Authorization Configuration
Defaults
If port-string is not specified, quiet period will be set for all ports.
Mode
Switch command, read-write.
Example
This example shows how to set the PWA quiet period to 30 seconds for ports ge.1.5-7:
C3(su)->set pwa quietperiod 30 ge.1.5-7
set pwa maxrequest
Use this command to set the maximum number of log on attempts allowed before transitioning
the PWA port to a held state.
Syntax
set pwa maxrequests requests [port-string]
Parameters
Defaults
If port-string is not specified, maximum requests will be set for all ports.
Mode
Switch command, read-write.
Example
This example shows how to set the PWA maximum requests to 3 for all ports:
C3(su)->set pwa maxrequests 3
set pwa portcontrol
This command enables or disables PWA authentication on select ports.
Syntax
set pwa portcontrol {enable | disable} [port-string]
maxrequests Specifies the maximum number of log on attempts.
port-string (Optional) Sets the maximum requests for specific port(s). For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.