Enterasys C3G124-24 - Commands; Show Snmp Notify

show snmp notify
Enterasys C3 Configuration Guide 12-29
are associated with security and authorization criteria (target parameters) and mapped to a
management target address, refer to “Creating a Basic SNMP Trap Configuration” on page 12-35.
Commands
show snmp notify
Use this command to display the SNMP notify configuration, which determines the management
targets that will receive SNMP notifications.
Syntax
show snmp notify [notify] [volatile | nonvolatile | read-only]
Parameters
Defaults
If a notify name is not specified, all entries will be displayed.
If volatile, nonvolatile, or read-only are not specified, all storage type entries will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display the SNMP notify information:
C3(su)->show snmp notify
--- SNMP notifyTable information ---
Notify name = 1
Notify Tag = Console
For information about... Refer to page...
show snmp notify 12-29
set snmp notify 12-30
clear snmp notify 12-31
show snmp notifyfilter 12-31
set snmp notifyfilter 12-32
clear snmp notifyfilter 12-33
show snmp notifyprofile 12-33
set snmp notifyprofile 12-34
clear snmp notifyprofile 12-35
notify (Optional) Displays notify entries for a specific notify name.
volatile |
nonvolatile | read-
only
(Optional) Displays notify entries for a specific storage type.