Configuring IPsec set ipsec ike version
33-6
Defaults
The default Phase 1 mode is main.
Mode
Switch command, read-write, if the security profile = normal.
Switch command, super-user, if the security profile = C2.
Example
This example sets the Phase 1 mode to main.
C3(su)->set ipsec ike phase1 main
set ipsec ike version
Use this command to set the version of the IKE protocol.
Syntax
set ipsec ike version {ikev1 | ikev2}
Parameters
Defaults
IKE version 1 is the default.
Mode
Switch command, read-write, if the security profile = normal.
Switch command, super-user, if the security profile = C2.
Example
This example sets the IKE version to version 1.
C3(su)->set ipsec ike version ikev1
aggressive A faster, less secure, mode that uses only three messages, which
exchange Diffie-Hellman data and identify the two VPN endpoints.
Note: Currently, only IKE version 1 is supported.
ikev1 Select IKE version 1 to be used for IPsec. This is the default.
ikev2 Select IKE version 2 to be used for IPsec.
To Next Page
Loading...
