show ipv6 route summary
Enterasys C3 Configuration Guide 29-27
Usage
Lower numbers have a greater preference. A route with a preference of 255 cannot be used to
forward traffic.
The default preference value for static routes can be set with the ipv6 route distance command.
The distance for a specific static route can be set with the ipv6 route command.
Example
The following example shows the output of this command.
C3(su)->router#show ipv6 route preferences
Local 0
Static 1
OSPF Intra 8
OSPF Inter 10
OSPF Ext T1 13
OSPF Ext T2 150
OSPF NSSA T1 14
OSPF NSSA T2 151
Table 29-3 provides an explanation of the command output.
show ipv6 route summary
This command displays the summary of the routing table.
Syntax
show ipv6 route summary [all]
Parameters
Note: The configuration of NSSA preferences is not supported in this release.
Table 29-3 show ipv6 route preferences Output Details
Output Field What It Displays...
Local Preference of directly-connected routes.
Static Preference of static routes.
OSPF Intra Preference of routes within the OSPF area.
OSPF Inter Preference of routes to other OSPF routes that are outside of the
area.
OSPF Ext T1 Preference of OSPF Type-1 external routes.
OSPF Est T2 Preference of OSPF Type-2 external routes.
OSPF NSSA T1 Preference of OSPF NSSA Type 1 routes.
OSPF NSS! T2 Preference of OSPF NSSA Type 2 routes.
all (Optional) Display the count summary for all routes, including best and
non-best routes.
To Next Page
Loading...
Need help?
General