Enterasys C3G124-24 - Set Port Advertise

set port advertise
Enterasys C3 Configuration Guide 11-17
Mode
Switch command, read-only.
Example
This example shows how to display advertisement status for ports 13 and 14:
C3(su)->show port advertise ge.1.13-14
ge.1.13 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no
ge.1.14 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no
set port advertise
Use this command to configure what a port will advertise for speed/duplex capabilities in auto-
negotiation.
Syntax
set port advertise {port-string}{10t | 10tfd | 100tx | 100txfd | 1000t | 1000tfd
| pause}
Parameters
Defaults
None.
port-string Select the ports for which to configure advertisements. For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.
10t Advertise 10BASE-T half duplex mode.
10tfd Advertise 10BASE-T full duplex mode.
100tx Advertise 100BASE-TX half duplex mode.
100txfd Advertise 100BASE-TX full duplex mode.
1000t Advertise 1000BASE-T half duplex mode.
1000tfd Advertise 1000BASE-T full duplex mode.
pause Advertise PAUSE for full-duplex links.