set lacp
Enterasys C3 Configuration Guide 11-49
set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) globally on
the device.
Syntax
set lacp {disable | enable}
Parameters
Defaults
By default, the global LACP state is enabled, enabled per port.
Mode
Switch command, read-write.
Usage
This command configures the global state of LACP on the switch. Use the command “set port
lacp” on page 11-55 to enable/disable LACP per port.
Example
This example shows how to disable LACP globally:
C3(su)->set lacp disable
set lacp asyspri
Use this command to set the LACP system priority to be used in creating a LAG (Link
Aggregation Group) ID.
Syntax
set lacp asyspri value
Parameters
Defaults
None.
Oper Key Port’s operational key, derived from the admin key. Only underlying physical ports
with oper keys matching the aggregator’s will be allowed to aggregate.
Attached Ports Underlying physical ports associated with this aggregator.
Table 11-7 show lacp Output Details (Continued)
Output Field What It Displays...
disable | enable Disables or enables LACP.
value Specifies a system priority value. Valid values are 0 to 65535, with
precedence given to lower values. The default system priority is 32768.
To Next Page
Loading...
Need help?
General