set igmpsnooping adminmode
Enterasys C3 Configuration Guide 17-3
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Usage
Configured information is displayed whether or not IGMP snooping is enabled. Status
information is displayed only when the function is enabled. For information on enabling IGMP on
the system, refer to “set igmpsnooping adminmode” on page 17-3. For information on enabling
IGMP on one or more ports, refer to “set igmpsnooping interfacemode” on page 17-4.
Example
This example shows how to display IGMP snooping information:
C3(su)->show igmpsnooping
Admin Mode..................................... Enable
Group Membership Interval...................... 260
Max Response Time.............................. 100
Multicast Router Present Expiration Time....... 0
Interfaces Enabled for IGMP Snooping........... ge.1.1,ge.1.2,ge.1.3
Multicast Control Frame Count.................. 0
Data Frames Forwarded by the CPU............... 0 set
set igmpsnooping adminmode
Use this command to enable or disable IGMP on the system.
Syntax
set igmpsnooping adminmode {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Usage
In order for IGMP snooping to be enabled on one or all ports, it must be globally enabled on the
device with this command, and then enabled on a port(s) using the set igmpsnooping interface
mode command as described in “set igmpsnooping interfacemode” on page 17-4.
enable | disable Enables or disables IGMP snooping on the system.
To Next Page
Loading...
