show port status
Enterasys C3 Configuration Guide 11-3
Parameters
Defaults
If port-string is not specified, operational status information for all ports will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display operational status information for ge.3.14:
C3(su)->show port ge.3.14
Port ge.3.14 enabled
show port status
Use this command to display operating and admin status, speed, duplex mode and port type for
one or more ports on the device.
Syntax
show port status [port-string]
Parameters
Defaults
If port-string is not specified, status information for all ports will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display status information for ge.1.1 and ge.1.2:
C3(su)->show port status ge.1.1-2
Alias Oper Admin Speed
Port (truncated) Status Status (bps) Duplex Type
--------- ------------ ------- ------- --------- ------- ------------
ge.1.47 Down Up N/A N/A RJ45
ge.1.48 Up Up 1.0G full RJ45
Table 11-1 provides an explanation of the command output.
port-string (Optional) Displays operational status for specific port(s). For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.
port-string (Optional) Displays status for specific port(s). For a detailed description of
possible port-string values, refer to “Port String Syntax Used in the CLI” on
page 11-1.
To Next Page
Loading...
Need help?
General