Enterasys C3G124-24 User Manual

set length
3-24 Basic Configuration
Defaults
None.
Mode
Switch command, read-write.
Usage
The number of rows of CLI output displayed is set using the set length command as described in
“set length” on page 3-24.
Example
This example shows how to set the terminal columns to 50:
C3(su)->set width 50
set length
Use this command to set the number of lines the CLI will display. This command is persistent
(written to NV-RAM).
Syntax
set length screenlength
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the terminal length to 50:
C3(su)->set length 50
show logout
Use this command to display the time (in seconds) an idle console, Telnet, or SSH CLI session will
remain connected before timing out.
Syntax
show logout
screenlength Sets the number of lines in the CLI display. Valid values are 0, which
disables the scrolling screen feature described in “Displaying Scrolling
Screens” on page 1-9, and from 5 to 512.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English