ipv6 dhcp relay-agent-info-remote-id-subopt
30-4 DHCPv6 Configuration
ipv6 dhcp relay-agent-info-remote-id-subopt
This command configures a number to represent the DHCPv6 Relay Agent Remote-ID sub-option.
Syntax
ipv6 dhcp relay-agent-info-remote-id-subopt option
Parameters
Defaults
The default value of the DHCPv6 Relay Agent Remote-ID sub-option is 1.
Mode
Router global configuration: C3(su)->router(Config)#
Usage
This sub-option may be added by DHCP relay agents which terminate switched or permanent
circuits and have mechanisms to identify the remote host end of the circuit. Refer to RFC 3046 for
more information.
Example
This example sets the Relay Agent Remote-ID sub-option value to 2.
C3(su)->router(Config)# ipv6 dhcp relay-agent-info-remote-id-subopt 2
ipv6 dhcp pool
This command allows you to enter IPv6 DHCP pool configuration mode for the specified pool
name.
Syntax
ipv6 dhcp pool pool-name
no ipv6 dhcp pool pool-name
Parameters
Defaults
None.
Mode
Router global configuration: C3(su)->router(Config)#
option The value of option may range from 1 to 65535. The default value is 1.
pool-name Specifies the name of the pool to be configured. Pool names must be less
than 31 alpha-numeric characters.
To Next Page
Loading...
Need help?
General