show ip pimsm interface
27-42 IPv4 Advanced Routing Protocol Configuration
COMPONENT TABLE
Component Component Component Component
Index BSR Address BSR Expiry Time CRP Hold Time
(hh:mm:ss) (hh:mm:ss)
---------- --------------- --------------- -------------
1 192.168.30.2 00:02:10 00:00:00
Table 27-8 provides an explanation of the command output.
show ip pimsm interface
This command displays PIM-SM status of the router interfaces. With the stats parameter, this
command displays statistical information for PIM-SM on the specified interface.
Syntax
show ip pimsm interface {vlan vlan-id | stats {vlan-id | all}}
Parameters
Defaults
None.
Mode
Any router mode.
Examples
This example shows how to display PIM interface information.
.
C3(su)->router> show ip pimsm interface vlan 30
VLAN ID 30
IP Address 192.168.30.1
Subnet Mask 255.255.255.0
Mode enable
Table 27-8 show ip pimsm componenettable Output Details
Output Field What it displays
Component Index This field displays a number which uniquely identifies the component.
Component BSR
Address
This field displays the IP address of the bootstrap router (BSR) for the local PIM
region.
Component BSR
Expiry Time
This field displays the minimum time remaining before the BSR in the local domain
will be declared down.
Component CRP
Hold Time
This field displays the hold time of the component when it is a candidate rendezvous
point.
vlan vlan-id Display PIM-SM information for the specified IP interface enabled for
PIM.
stats Display PIM-SM interface statistics.
vlan-id | all Display statistics for a specific VLAN or all VLANs.
To Next Page
Loading...
Need help?
General