show radius accounting
32-12 Authentication and Authorization Configuration
show radius accounting
Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
Syntax
show radius accounting [server] | [counter ip-address] | [retries] | [timeout]
Parameters
Mode
Switch command, read-only.
Defaults
If no parameters are specified, all RADIUS accounting configuration information will be
displayed.
Example
This example shows how to display RADIUS accounting configuration information. In this case,
RADIUS accounting is not currently enabled and global default settings have not been changed.
One server has been configured.
For details on enabling and configuring RADIUS accounting, refer to “set radius accounting” on
page 32-12:
C3(ro)->show radius accounting
RADIUS accounting status: Disabled
RADIUS Acct Server IP Address Acct-Port Retries Timeout Status
------------------ ---------- --------- ------- ------- ------
1 172.16.2.10 1856 3 20 Disabled
set radius accounting
Use this command to configure RADIUS accounting.
Syntax
set radius accounting {[enable | disable] [retries retries] [timeout timeout]
[server ip_address port [server-secret]
Parameters
server (Optional) Displays one or all RADIUS accounting server configurations.
counter ip-address (Optional) Displays counters for a RADIUS accounting server.
retries (Optional) Displays the maximum number of attempts to contact the
RADIUS accounting server before timing out.
timeout (Optional) Displays the maximum amount of time before timing out.
enable | disable Enables or disables the RADIUS accounting client.
retries retries Sets the maximum number of attempts to contact a specified RADIUS
accounting server before timing out. Valid retry values are 0 - 10.
To Next Page
Loading...
