Enterasys C3G124-24 - Set Lldp Port Location-Info

set lldp port location-info
Enterasys C3 Configuration Guide 10-27
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example enables transmitting LLDP-MED traps on ports ge.1.1 through ge.1.6.
C3(rw)->set lldp port med-trap enable ge.1.1-6
set lldp port location-info
Use this command to configure LLDP-MED location information on a port or range of ports.
Currently, only Emergency Call Services (ECS) Emergency Location Identification Number (ELIN)
is supported.
Syntax
set lldp port location-info elin elin-string port-string
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
After you configure a location information value, you must also configure the port to send the
Location Information TLV with the set lldp port tx-tlv command. This example configures the
ELIN identifier 5551234567 on ports ge.1.1 through ge.1.6 and then configures the ports to send
the Location Information TLV.
C3(rw)->set lldp port location-info 5551234567 ge.1.1-6
C3(rw)->set lldp port tx-tlv med-loc ge.1.1-6
enable Enables transmitting LLDP-MED traps on the specified ports.
disable Disables transmitting LLDP-MED traps on the specified ports.
port-string Specifies the port or range of ports to be affected.
elin Specifies that the ECS ELIN data format is to be used.
elin-string Specifies the location identifier. Value can be from 10 to 25 numerical
characters.
port-string Specifies the port or range of ports to be affected.