set ip protocol
3-6 Basic Configuration
set ip protocol
Use this command to specify the protocol used to acquire a network IP address for switch
management.
Syntax
set ip protocol {bootp | dhcp | none}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the method used to acquire a network IP address to DHCP.
C3(su)->set ip protocol dhcp
show ip route
Use this command to display the IP route table.
Syntax
show ip route
Parameters
None.
Defaults
None.
Mode
Switch command, read only.
Example
This example shows the output of this command.
C3(ro)->show ip route
INET route table
Destination Gateway Flags Use If Metric
0.0.0.0/0 61.200.10.1 UG 5112086 host 5
61.200.10.0/24 61.200.10.10 UC 59 host 5
bootp Selects BOOTP as the protocol to use to acquire the system IP address.
dhcp Selects DHCP as the protocol to use to acquire the system IP address.
none No protocol will be used to acquire the system IP address.
To Next Page
Loading...
