show time
3-14 Basic Configuration
Defaults
None.
Mode
Switch command, read-write.
Usage
This command resets all the high temperature parameters to their default values:
• Syslog alerts are disabled by default.
• Trap alerts are disabled by default.
• Overtemp threshold is 100% by default.
Example
This example resets all high temperature parameters to their defaults.
C3(su)->clear system temperature
show time
Use this command to display the current time of day in the system clock.
Syntax
show time
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the current time. The output shows the day of the week,
month, day, and the time of day in hours, minutes, and seconds and the year:
C3(su)->show time
THU SEP 05 09:21:57 2002
set time
Use this command to change the time of day on the system clock.
Syntax
set time [mm/dd/yyyy] [hh:mm:ss]
To Next Page
Loading...
Need help?
General