show system lockout
Enterasys C3 Configuration Guide 5-17
show system lockout
Use this command to display settings for locking out users after failed attempts to log in to the
system.
Syntax
show system lockout
Parameters
None.
Defaults
None.
Mode
Switch command, super user.
Example
This example shows how to display user lockout settings. In this case, switch defaults have not
been changed:
C3(su)->show system lockout
Unsuccessful login attempts before lockout : 3
Duration of lockout : 1 minutes.
Period of inactivity before account lockout : 90 days
Lockout entire port upon failed logins : enabled
Ports currently locked out due to failed logins : none
Account assigned emergency-access from the console: admin
Table 5-3 provides an explanation of the command output. These settings are configured with the
set system lockout command (page 5-18).
Table 5-3 show system lockout Output Details
Output Field What It Displays...
Unsuccessful login attempts before
account lockout
Number of failed login attempts allowed before a read-write or
read-only user’s account will be disabled or a super-user account
will be locked out for a period of time.
Duration of lockout Number of minutes super-user accounts will be locked out after
the maximum failed login attempts or period of inactivity.
Period of inactivity before account
lockout
Number of days of inactivity before a read-write or read-only
user’s account will be disabled or a super-user account will be
locked out for a period of time. Zero indicates that no lockout will
occur for inactivity.
Lockout entire port upon failed logins Enabled or disabled.
Ports currently locked out due to failed
logins
Ports currently locked out due to failed logins will show network
and/or console if engaged.
Account assigned emergency-access
from the console
The user account allowed emergency access through the console
port.
To Next Page
Loading...
Need help?
General