Global OSPFv3 Configuration Commands
Enterasys C3 Configuration Guide 31-3
Global OSPFv3 Configuration Commands
Purpose
These commands are used to configure a router ID for the OSPFv3 router, to enter router OSPFv3
configuration mode, and to configure global OSPFv3 parameters.
Commands
ipv6 router id
This command configures a 32-bit integer, entered in 32-bit dotted-quad notation, used to
uniquely identify this OSPFv3 router.
Syntax
ipv6 router id ip-address
Parameters
Defaults
None.
Mode
Router global configuration: C3(su)->router(Config)#
Usage
Use this command to configure the OSPFv3 router ID.
For information about... Refer to page...
ipv6 router id 31-3
ipv6 router ospf 31-4
default-information originate 31-4
default-metric 31-5
distance ospf 31-6
exit-overflow-interval 31-7
external-lsdb-limit 31-7
maximum-paths 31-8
redistribute 31-8
passive-interface 31-9
ip-address Specifies the ID of the OSPFv3 router, in 32-bit dotted-quad notation.
To Next Page
Loading...
