show snmp persistmode
Enterasys C3 Configuration Guide 3-35
You can change the persistence mode from “auto” to “manual” with the set snmp persistmode
command. If the persistence mode is set to “manual,” configuration commands will not be
automatically written to NVRAM. Although the configuration commands will actively modify the
running configuration, they will not persist across a reset unless the save config command has
been executed.
Purpose
To set and view the persistence mode for CLI configuration commands, manually save the
running configuration, view, manage, and execute configuration files and image files, and set and
view TFTP parameters.
Commands
show snmp persistmode
Use this command to display the configuration persistence mode setting.
Syntax
show snmp persistmode
Parameters
None.
Note: When your device is configured for manual SNMP persistence mode, and you attempt to
change the boot system image, the device will not prompt you to save changes or warn you that
changes will be lost.
For information about... Refer to page...
show snmp persistmode 3-35
set snmp persistmode 3-36
save config 3-37
dir 3-37
show file 3-38
show config 3-39
configure 3-40
copy 3-41
delete 3-42
show tftp settings 3-42
set tftp timeout 3-43
clear tftp timeout 3-43
set tftp retry 3-44
clear tftp retry 3-44
To Next Page
Loading...
Need help?
General